Recently, I thought I’d check the internet to see what was posted relative to bending steel. It is a very broad subject, like asking “What is the price of a car?”

Very difficult to answer without lots of clarification, clarification not only relative to the nature of the steel, the hardness, the bend, the bend radius, the equipment, the operator, and so on. Will you be cold bending, or applying heat? Quickly run through the above questions and then give some thought to the tools you might be using you to bend the steel: pliers, hammer, garden tools? You’ll want to add some simple protective gear (for hands, face, head, feet, etc.)

BENDING STEEL IS POTENTIALLY DANGEROUS. I’m not telling you not to attempt bending steel. But, if you’re a novice (beginner), your first consideration should be to have a professional, or experienced individual do it. If that is just not an option, then approach bending any steel with a high degree of caution. Bending even a small thin strip of steel may result in problems, including serious injury.

One foolproof caution a novice should employ before attempting to bend steel is this: Hold the bar of steel close enough to clearly see the surface finish and the sharp edges. Grasp it firmly in both hands and look closely to see if you can determine grain direction. Whack yourself in the forehead. It should hurt, causing you to reconsider what you are considering doing, or at least to insure you exercise extra caution and make use of safety gear such as gloves, safety goggles, helmet, whatever.

BENDING STEEL IS DANGEROUS!  BENDING HARDENED STEEL IS NOT ONLY DANGEROUS; IT IS POTENTIALLY DEADLY. How do you determine if it is soft steel or if it has been hardened?

If you can grip it in both hands and bend it, it’s probably on the softer side. If you feel that it should be bending but it’s not budging, it’s time for some extra caution. It might be a piece of steel that is dead hard. If you hit that with a hammer, or even if you just apply too much force, it may shatter, discharging projectile pieces.

In general, avoid tight radius bends. Slow, minimal curves are safer for you, your neighbors, and the steel. If you do need to make a 90-degree bend, the curve at the point of the bend (bend radius) will have to be large, maybe ever 2” diameter or greater. If that is not going to work for your project, it’s time to consider that your attempted blacksmithing is perhaps ill conceived.

Bending steel at colder temperatures is riskier than bending it at higher temperatures.

Granted, that makes handling it more difficult, but the chances of successful results are increased.

When you anticipate bending steel, whether it is behind the garage at home or in your basement, respect it as a serious material and approach it with the caution it deserves; think danger like you would if you were working with large hungry predatory cats, people prone to projectile vomiting, or high voltage electrical current.

-Howard Thomas, November 6th 2020

0 0 votes
Article Rating
Subscribe
Notify of
guest

0 Comments
Oldest
Newest Most Voted
Inline Feedbacks
View all comments